Loading... Please wait...

Our Newsletter

Midmark M9 Autoclave Ultraclave Ritter Sterilizer

  • Midmark M9 Autoclave Ultraclave Ritter Sterilizer
81.00 LBS
24 Hours
Calculated at checkout
Bookmark and Share

Product Description


Overall length w / plug: 20.13 "(51 cm)
Width: 15.3 "(38.9 cm)
W total height / printer: 15.8 "(40.1 cm)
Countertop Area: 15.3 "x 20.38" (38.9 cm x 51.8 cm)
Camera: 9 "diameter (22.9 cm) 15" deep (38.0 cm) 3.5 gal. useful volume (13.4 liters)
Trays: Two large - 7 5/16 "W x 12" L x 7/8 "D (18.6 cm x 30.5 cm x 2.2 cm) Two small - 5 5/8" W x 12 "L x 7/8" D (14.3 cm x 30.5 cm x 2.2 cm)
Unit Weight: 73 lbs. (33.1 kg)
Shipping Weight: 81 lbs. (36.7 kg)
Water tank capacity: 1.1 gal. (4.1 liters)
Electrical Requirements: 115 VAC, 50/60 Hz, single phase 15 amp, 115 VAC has 1425 watt tubular immersion heater, UL61010A-1, UL61010-2-041, CAN  / CSA C22.2 No. 1010, CAN / CSA C22 0.2 No. 1010.2-041-96


M9 UltraClave Features:

Removal technology air pulses
Steam-Flush Pressure-Pulse Air Removal System of the M9 is so efficient that it can pass the air removal tests required on systems vacuum steam    autoclave more complex, ensuring good steam penetration for those loads difficult. In addition, less complexity means better reliability and an economical solution for your sterilization needs.

Convenience at a glance
The LCD display indicates cycle selected, cycle temperature and exposure time. When the cycle enters sterilization mode, temperature, pressure, and the remaining cycle time shown. Remaining cycle time is also shown in the dry mode. Note: The temperature and pressure are not displayed in the dry mode.

No instruments wetter
Once sterilization is complete, the autoclave door automatically opens and silently to dispel water vapor and drying the instruments. You'll have dry, sterile instruments every time.

Security Features
If the door is not completely closed or the reservoir water level is low, the LCD provides the appropriate message. In any case, sterilization will not continue until you have attended the unit.

Easy Drain and Fill
For ease of emptying and filling the tank fill port M9 and the drain are at the front of the unit, at the top or at the rear.

Optional Printer Accessory
The M9 printer accessory provides a permanent record of the cycles, temperatures and pressures during a cycle.

Auto Program Controls
Programmable controls allow the creation of different sterilization cycle parameters for special needs. Programmable buttons allow you to change the following: Exposure time (3-90 minutes), temperature (230-275 ° F), Dry Time (0 to 60 minutes), or Vent (slow or fast). The buttons # 1 and # 2 allow you to store the change if desired.

Pre-Programmed Controls
Four sterilization cycle controls preprogrammed: Unwrapped (132 ° C or 270 ° C for 3 minutes), bags (132 ° C or 270 ° C for 5 minutes), Packs (121 ° C or 250 ° F for 30 minutes ) Handpieces (unwrapped and pouched) (132 º C or 270 º C for 6 minutes).

LCD Display
Indicates cycle selected, temperature and exposure time. During the cycle, the display shows messages describing the state of the cycle. When the cycle enters the sterilizing mode, the remaining time is displayed as well as temperature and pressure.

Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the Midmark M9 Autoclave Ultraclave Ritter Sterilizer to your wish list.

You Recently Viewed...